Pre Curved Shower Seals
Pre curved shower seals are a custom enquiry for curved shower door bottoms. Share your glass geometry and profile drawing or sample so the section, bend and installation direction can be reviewed together.
Start With the Glass and Seal Position
Identify the actual curve of the glass or door and show where the seal will sit. A selected section and curvature must be agreed for each project; not every shower seal section can be pre-curved for every installation.
Mark the inside and outside of the enclosure, the direction of the bend and the intended orientation of the section and any drip edge. This helps the team review the shape against the installation before sample fitting.
Drawing and Measurement Checklist
Use a drawing, CAD model or marked sample to define the following inputs. Measure along the intended installation path and identify the reference used for each dimension.
| Field | What You Supply |
|---|---|
| Profile section | Drawing or matching sample |
| Glass thickness (mm) | Nominal mating glass thickness |
| Mating section dimensions (mm) | Free-state dimensions; channel opening if applicable |
| Curvature radius (mm) | Radius and measurement reference |
| Arc length (mm) | Length along installation path |
| Chord length (mm) | Straight distance between ends |
| Orientation | Inside, outside and any drip direction |
| Gap and any contact features (mm) | Installation gap and contact position |
| Length tolerance and packing | Project requirements for review |
Define whether the radius is measured at the inner edge, centreline or outer edge; do not estimate it from a photograph. Arc length and chord length describe different measurements and should be supplied separately.
Review the Glass Interface
Where the selected profile has a glass-receiving channel, nominal glass thickness describes the mating glass, while the channel opening describes the profile in its free state before installation. They are separate dimensions: the mating range and installed fit depend on the section and must be reviewed for the project.
Show how the seal is installed, where any contact lip meets the adjoining surface and whether the door moves past nearby fittings. Provide the available clearance and any constraints at the ends of the curved glass.
Sample Fitting and Handling
- Review the drawing or sample, glass curve and orientation with TOSEN to identify a section and curvature for evaluation.
- Check the agreed sample against the drawing, including the free-state section, curve, length and direction.
- Trial-fit it on the intended glass and review the mating fit, any lip position, end alignment and movement clearance. Record any changes for the next review.
Discuss packing and handling requirements for the agreed shape, including how parts will be supported and removed without forced bending. Confirm the approach as part of the project review.
Request a Project Quotation
Send your drawing, CAD model or sample details, together with the measurements above, estimated quantity, material or colour requirements, delivery destination and required schedule. Include any specified testing or acceptance requirements. Explore our custom extrusion solutions or contact TOSEN to discuss the project.
For an ordinary door-bottom project, custom door sweep profiles address a different selection task from curved shower glass seals.