Custom Plastic Edge Protection Profiles

Custom plastic edge protection profiles begin with the edge you need to cover. Share a drawing or sample with TOSEN so we can review the section, contact surfaces and installation requirements for your panel or equipment project.

Define the Edge and Its Purpose

Show whether the profile follows a straight edge, a curved edge or a corner. Identify the surfaces it may cover and any adjacent features that must remain clear.

Tell us whether the section is intended to cover the edge, provide cushioning, hold onto the panel or combine these functions. The profile geometry and fixing method should be reviewed against the actual application.

Prepare Your Drawing Inputs

Mark the mating part and the proposed profile separately. Include a cross-section and, where applicable, a view of the full edge path.

Field What You Supply
Panel Edge Thickness and shape (mm)
Contact Surfaces Substrate and surface finish
Coverage Allowed cover width (mm)
Profile Section Slot depth and wall thickness (mm)
Curves and Corners Edge geometry and installation constraints
Material and Hardness Requirements and hardness scale, if specified
Appearance Colour and finish requirements
Length Required finished length (mm)

Distinguish the nominal dimensions of the panel or mating edge from the profile’s free-state geometry before installation. A flexible section may change shape when fitted, so the drawing should identify the intended contact and installed position as well as any critical dimensions and tolerances.

Review the Interface and Fixing Method

Which surfaces may touch the profile, and are there scratch or contamination concerns? Show the available installation space, the direction of fitting, and any features that could obstruct assembly.

Specify the intended fixing method and whether the profile must stay in place during handling. For curved edges, provide the actual edge geometry and explain how the section must follow it. Identify how ends and corners should meet; confirm the proposed arrangement for the project.

Review a Sample Against the Assembly

  1. Share the edge drawing or a representative sample, along with the proposed section and intended fixing method.
  2. Review the profile design and material requirements with TOSEN for the application.
  3. Check the sample on the actual mating edge for fit, contact, coverage, installation and appearance. Record any changes needed before approval.

For a broader view of the development process, see TOSEN’s custom extrusion solutions.

Request a Project Quotation

Send your drawing, 3D model or sample details, edge and contact requirements, intended use and service environment. Include your material, colour and finish requirements; finished length; estimated quantity; any testing requirements; and delivery destination and schedule. Contact TOSEN to discuss the project.

If the primary task is locating or engaging a section in a channel, see custom plastic U channels. This is a separate selection task: its fixing method also needs to be confirmed for the project.