Custom Plastic Cable Trunking Profiles

Custom plastic cable trunking profiles start with the space your cable bundle needs and the way the section will be installed and accessed. Send TOSEN a drawing or sample to discuss a channel, a cover strip, or another defined profile for your project.

Cable Routing and Access Requirements

First, identify the component you need: a continuous channel, a separate cover, or both. Show where the cables enter and exit, the installation surface, and the space available around the route.

Consider how the installer will place the cables and how maintenance personnel will reach them. If a cover is part of the design, indicate the space needed to open and remove it.

Section Drawing Checklist

A dimensioned cross-section helps us review the profile against your cable bundle and installation space. Mark critical dimensions and any tolerances required by your project.

Field What You Supply
Component Scope Channel, cover or both
External Dimensions Section width and height (mm)
Usable Internal Space Clear width and height (mm)
Cable Bundle Bundle dimensions and layout (mm)
Mating Features Opening and engagement dimensions (mm), if applicable
Fixing and Finishing Fixing method, holes or cuts
Length and Packaging Cut length (mm or m) and packing needs

Cover Interfaces and Fixing

If your design includes a base and cover, provide drawings or samples of both and identify which parts are included in the enquiry. Show the intended engagement points, assembly direction and removal method, as well as any nearby features that limit access.

Distinguish the nominal dimensions of the mating parts from the profile’s free-state geometry before assembly. Where a feature flexes during fitting, show its intended position when installed and discuss the fit during sample review.

Specify how the section attaches to its mounting surface. Identify any requested holes, adhesive or other fixing method on the drawing; cutting and additional processing are subject to project review.

Materials and Application Conditions

Share the installation environment and any material, colour or surface requirements. If your application requires electrical insulation, flame performance, temperature testing or certification, include the relevant requirements and evidence needed for review.

This enquiry concerns profile development; the profile should be assessed within your complete application and its applicable requirements.

Drawing and Sample Review

  1. Send the section drawing, a 3D model or a physical sample, together with the mating information.
  2. Review the proposed section, material requirements and any requested finishing with TOSEN.
  3. When samples are agreed, check the section and usable space against your drawing, then assess installation, cover engagement and maintenance access with the actual mating parts.
  4. Share your observations and agree any changes before confirming the project requirements.

Request a Project Quotation

For a quotation, send your drawing or sample, component scope, cable bundle dimensions, fixing and access requirements, estimated quantity, requested length and packaging, test requirements, delivery destination and desired schedule. You can review the wider custom extrusion solutions or contact TOSEN with your project details.

For a different selection task involving panel edging or channel engagement, see custom plastic U channels; mating with a cable trunking design would need a separate review.