Custom Plastic U Channels
Develop a custom plastic U channel around your panel, slot and installation requirements. Share a cross-section drawing or sample with TOSEN to review the profile for your application.
Choose by Panel and Slot Fit
U channels can be considered for clip-in fitting, positioning, edging or engagement with a mating part. Begin with what the section must do and how it will be installed. A profile intended to locate a panel may need a different section from one intended to cover its edge.
Show the panel’s nominal thickness and tolerance separately from the channel’s free-state inside width. The free-state opening is measured before assembly; it is not the same as the panel thickness or the acceptable assembled fit. Review the intended fit and contact with a sample and the actual mating part.
Drawing Input Checklist
Mark the following on a cross-section drawing where applicable. A sample can also help explain the geometry and contact surfaces.
| Field | What the Buyer Supplies |
|---|---|
| Panel thickness | Nominal thickness and tolerance in mm, including any surface finish that affects the fit. |
| Free-state slot | Inside opening width in mm before assembly and the intended contact areas. |
| Channel section | Slot depth, outside width, wall thickness and any required lip or edge geometry in mm. |
| Installation | Insertion direction, available space and intended method of holding the channel in position. |
| Material and appearance | Any specified material, hardness, colour and surface requirements, plus the service environment. |
| Length and finishing | Cut length in mm or m, end treatment and packaging requirements. |
Confirm the Mating Interface
Will the channel slide onto the panel or be pressed into place? Which surfaces should touch, and must the profile remain removable? Identify nearby parts and any assembly clearance on the drawing. If friction grip is intended, describe the required fit and review it with the actual panel; a U-shaped section does not automatically hold by friction. Specify any other fixing method as part of the project.
Review the Sample
- Share the drawing or sample, panel dimensions and installation requirements for engineering review.
- Discuss the proposed section and whether an existing tool can be matched or new tooling needs evaluation.
- Review a sample against the drawing, then assemble it with the mating part to check insertion, contact and retention under the agreed project conditions.
- Record any changes and confirm the sample and requirements before production is agreed.
Request a Project Quotation
Send your drawing, 3D model or sample, panel thickness and tolerances, intended fixing method, application and environment. Include material or performance targets, colour, finish, length, estimated quantity, testing requirements, delivery destination and requested schedule. Contact TOSEN to discuss the project, or explore our custom extrusion solutions.
If the main selection task is covering and cushioning an exposed edge, see custom plastic edge protection profiles. That is a separate profile selection; any mating relationship must be reviewed for the project.