Custom Plastic Guide Profiles
Custom plastic guide profiles are developed around the moving part and the path it needs to follow. Send TOSEN your section drawing or sample, mating-part details and operating requirements to discuss a profile for your project.
Define the Guidance Task
Start with the component that moves and the direction of travel. In a door, furniture assembly or piece of equipment, the guide section may be intended to locate the moving part and limit sideways movement along a defined path.
Identify where contact occurs, which movement needs to be constrained and how much offset your assembly can allow. A section drawing with the mating part shown is more useful for this review than a profile photograph alone.
Drawing Input Checklist
Include the following information in your drawing, model or sample notes wherever available.
| Field | What You Supply |
|---|---|
| Moving Part and Path | Part drawing; travel direction |
| Guide Section | Cross-section dimensions (mm); contact surfaces |
| Clearance and Offset | Required clearance and allowable offset (mm) |
| Critical Tolerances | Fit dimensions and tolerances (mm) |
| Mounting and Length | Fixing method; locations; length (mm) |
| Ends and Assembly | End treatment; insertion direction |
| Material and Surface | Material, colour and finish requirements |
| Operating Conditions | Speed, load, temperature and cleaning conditions |
Distinguish the nominal dimensions of the mating part from the guide profile’s free-state geometry before assembly. Mark the intended assembled clearance separately, along with the measurement locations and tolerances that matter to the fit.
Review the Mating Interface
Show which surfaces touch during travel and where the moving part enters the guide. Indicate the mounting position, fixing points, assembly sequence and any adjacent features that could restrict insertion or movement.
Share the expected speed, load and environment as project inputs. If friction or wear is important, define the evaluation method and acceptance criteria for your application.
Sample Inspection and Trial Assembly
- Agree which section dimensions, contact surfaces and lengths to inspect, and how they will be measured.
- Fit the sample with the actual mating component and check the mounting arrangement and clearance.
- Move the assembly through its intended path and record any binding or unwanted offset.
- Review the results against your acceptance criteria and identify any drawing changes before production.
Project development can progress from application and drawing review to samples, inspection and approval, followed by production and finishing as agreed. See our custom extrusion solutions for the wider development process.
Request a Project Quotation
Send a section drawing, 3D model or physical sample, together with the mating-part drawing, motion path and critical fit requirements. Include your material or performance targets, required length, estimated quantity, test requirements, delivery destination and requested schedule.
For a separate static edging or locating task, consider custom plastic U channels; their fixing method needs to be defined for the project. To discuss your guide profile, contact TOSEN with your project details.