Custom Co Extruded Door Sweep Profiles
Develop a custom co-extruded door sweep around your door’s mounting details and floor gap. Share a drawing or sample so the rigid mounting section and flexible contact edge can be reviewed together.
Define the Door Bottom and Contact
The mounting section must suit the door material and the fixing method specified for the project. The flexible section must reach the intended floor contact area while allowing for the door’s opening and closing movement.
Measure the gap along the door’s travel and note changes in the floor surface. The required contact and compression should be checked in the actual assembly; flexible edge length alone does not define the installed gap.
Drawing Input Checklist
Provide the following information on a section drawing or with an annotated sample where available.
| Field | What You Supply |
|---|---|
| Door and fixing | Door material and fixing method |
| Mounting section | Section dimensions and hole positions, in mm |
| Door-bottom gap | Measured gaps and locations, in mm |
| Flexible edge | Free-state shape and edge length, in mm |
| Installed contact | Intended contact and compression, in mm |
| Material sections | Requirements and hardness scales for each section |
| Finished profile | Cut length, colour and finishing requirements |
Identify nominal mating dimensions on the door separately from the sweep’s free-state profile geometry. The installed contact shape can differ from the free-state drawing once the flexible edge meets the floor.
Review the Mating Interface
Show where the rigid section locates on the door, how it is secured and whether the fixing area has holes or other features. Include the available mounting space and any obstructions at the door ends.
Indicate the opening direction, floor contact surface and any changes in clearance during travel. Photos or a drawing of the assembled door help explain the relationship between the mounting area and the flexible edge.
Sample Review and Development
- Share the section drawing or sample with the door and floor measurements for engineering review.
- Review the proposed mounting geometry, material requirements and flexible contact position.
- Fit the agreed sample to the actual door and check fixing, contact and movement through opening and closing.
- Record any changes needed and confirm the agreed section and project requirements before production.
Choose the Right Profile Task
For a curved shower glass door, pre-curved shower seals address a different selection task involving agreed sections and curvatures. For covering a panel edge, consider custom edge protection profiles; their selection starts with the edge and panel interface.
Request a Project Quotation
Send your drawing, 3D model or sample, along with the measurements above, application environment, estimated quantity, required finish, destination and target schedule. Include any project-specific testing or certification requirements.
Explore our custom extrusion solutions or contact TOSEN to discuss your door sweep project.